Ball Drilling
Layout mapped to your rev rate, axis tilt and PAP, not a template. Measured, drilled and finished in-house.
⏱ 45 minIn-house work
Drilling & Custom Fitting
A ball drilled to someone else's hand will never roll right in yours. Everything below happens on-site, usually the same evening. Call for a quote. What it costs depends on the ball and the layout.
What we do
Services
Custom Fitting & PAP
Span, pitch and thumb sizing measured properly, plus your Positive Axis Point and rev rate. Skip the PAP and the layout is guesswork, however good the ball is.
⏱ 30 minThumb Slugs & Inserts
Slug and insert work to tighten a loose fit, plus interchangeable thumb systems.
⏱ 30 minPlugging & Re-Drill
Bring a used ball back to life with a fresh layout matched to your current game.
⏱ 2 to 3 daysSurface Adjustment
Resurface and re-grit to change how early the ball reads the lane. Cheapest way to make an old ball new.
⏱ 20 minBall Maintenance
Deep clean and oil extraction. Coverstocks absorb oil and go lifeless. This brings the reaction back.
⏱ 30 minThe process
How A Fitting Actually Goes
- 01
We measure
Span, thumb size, pitch and your natural release. Ten minutes with a fitting ball tells us more than any chart.
- 02
We map the layout
Your PAP, rev rate and axis tilt decide where the holes go. Same ball, two bowlers, two different layouts.
- 03
We drill and finish
Drilled, bevelled and surfaced in-house. Most jobs are done the same evening you come in.
- 04
You roll it here
Throw it on the lanes before you leave. If the fit is off we adjust it on the spot, no second trip.
